Walther PPQ/PDP Uncaptured Stainless Guide Rod

(13 customer reviews)


Walther PPQ/PDP One Piece Guide Rod (non-captured)

  • Works with all PPQ/P99/PDP Models in 9mm or 40 S&W (NOT 45 acp or 3.5″ PDP-F)
  • PDP and PPQ Models
  • Q5 & Q4 STEEL FRAME Require that selection! Steel Frame rods will work on Polymer Guns but not the other way around!
  • One piece stainless steel
  • Uses Glock recoil springs
  • Fluted to reduce spring drag
  • All PDP models use this rod (EXCEPT F-Series)
SKU: PPQGRU Categories: ,


Our newly designed, one piece stainless guide rod for Walther PDP & PPQ line allows for use of 1/4″ diameter springs to better tune your pistol.  This allows the use of any Glock spring in order to adjust the recoil impulse of the pistol.  Swiss turned from 300 series stainless, the rods will drop into any 4″ or 5″ PPQ OR 4, 4.5 and 5″ PDP Models.  The rods are fluted for lower friction. Made in USA

  • Will NOT work with PPQ45 or PDP-F 3.5″
  • Includes front washer to center spring in the slide (optional use)
  • Weighs 19.5 Grams

Compatible with GEN3 Glock 17/34 or 22/35 in conjunction with ISMI flat wire springs

Please watch the below video and note the install as it can be tricky to do freehand.

Additional information

Weight 3 oz
Dimensions 6 × 4 × 1 in

PPQ Steel Frame, PDP/PPQ9/40/Q5


ISMI 13lb Spring, No Spring

13 reviews for Walther PPQ/PDP Uncaptured Stainless Guide Rod

Based on 13 reviews
5 star
4 star
3 star
2 star
1 star
Showing 1 of 13 reviews (4 star). See all 13 reviews
  1. Joe (verified owner)

    Great machining runs great my only issue is its an absolute bear to install

    1 out of 1 people found this helpful. Was this review helpful to you?
Add a review

Your email address will not be published. Required fields are marked *

You may also like…